Avaya Configuring SNMP, BOOTP, DHCP, and RARP Services Uživatelský manuál stáhnout pdf (Strana 95)

Configuring RARP Services

4-3

Enabling RARP on an Interface

When you select a link or net module connector, or when you ﬁnish conﬁguring a

WAN circuit, the Select Protocols window appears (refer to Figure 1-1).

To enable RARP on an interface:

1. Select Reverse ARP from the Select Protocols menu.

When you select RARP, you automatically select IP.

2. Click on OK.

The IP Conﬁguration window appears (refer to Figure 1-2).

3. Edit the parameters on the screen.

Refer to “Enabling IP on an Interface” in Chapter 1 for guidelines.

4. Edit or accept the default values for the remaining IP interface

parameters, as follows:

• To accept the default values, click on OK.

Site Manager displays the Conﬁguration Manager window. You can now

customize RARP parameters for the IP interface (refer to “Accessing RARP

Parameters”).

• To edit all IP interface parameters, click on Details.

Refer to Conﬁguring IP Services for information about editing IP interface

parameters.

Accessing RARP Parameters

The remaining sections in this chapter describe how to use the Conﬁguration

Manager to edit RARP parameters.

Note: The window varies slightly according to circuit type, displaying only

those protocols that the circuit type supports.

Note: The instructions in this section assume that you have already conﬁgured

at least one IP interface on which you have enabled RARP. If you have not yet

conﬁgured an IP interface, or want to add additional IP interfaces, refer to

“Enabling RARP Services” for instructions.

1 2 ... 90 91 92 93 94 95 96 97 98 99 100 ... 107 108

Žádné komentáře

Avaya Configuring SNMP, BOOTP, DHCP, and RARP Services Uživatelský manuál Strana 95