Avaya Configuring Dial Services Uživatelský manuál stáhnout pdf (Strana 91)

Creating Line Pools

4-13

Parameter: Debug Mode

Default: Disable

Options: Enable | Disable

Function: Allows you to print debug log messages concerning the V.25bis or Raise

DTR connection setup.

Instructions: Select Enable if you want to see the debug log messages. If not, accept the

default, Disable.

MIB Object ID: 1.3.6.1.4.1.18.3.5.9.8.1.1.29

Conﬁguring ISDN Lines

The procedure for conﬁguring BRI at the physical layer is different from that of

PRI, so instructions for conﬁguring B channels are divided into two sections: BRI

Interfaces and PRI Interfaces. Once you set the physical layer, you can create a

line pool. At that point, the procedure for BRI and PRI is the same.

For the D channel, the default settings support most networks, so you do not have

to edit the D channel parameters. If you would like to modify the D channel, go to

“Modifying Line Pool Conﬁgurations” on page 4-49.

BRI Physical Interfaces

Before you begin, remember that BRI interfaces are only available on the AN and

ASN hardware platforms.

To conﬁgure BRI lines:

1. Begin at the Conﬁguration Manager window (refer to Figure 4-1).

2. Click on an ISDN connector, and Site Manager displays the Port

Application window (Figure 4-10).

Note: You cannot modify the D channel, until you conﬁgure at least one B

channel.

1 2 ... 86 87 88 89 90 91 92 93 94 95 96 ... 257 258

Žádné komentáře

Avaya Configuring Dial Services Uživatelský manuál Strana 91