Avaya Configuring IP Exterior Gateway Protocols (BGP and EGP) Uživatelský manuál stáhnout pdf (Strana 60)

Configuring IP Exterior Gateway Protocols (BGP and EGP)

3-16

308628-15.0 Rev 00

Configuring the BGP Soloist Slot Mask

By default, BGP runs as a soloist on a slot determined by the BGP soloist slot

mask. Nortel Networks recommends that the slot mask include only

nonforwarding slots, so that BGP operations (route calculation, for example)

occur on one slot while the other slots maintain maximum forwarding capability.

If the slot on which the soloist is running fails, BGP runs on an eligible slot. By

default, BGP considers all slots with IP interfaces to be eligible slots. You can use

the BCC or Site Manager to specify one or more slots for the BGP soloist.

Using the BCC

To configure the BGP slot mask, go to the BGP prompt (for example,

box; ip;

/jointfilesconvert/97454/bgp

) and enter:

slot-mask

slot>

slot

is one of the values listed in Table 3-2. To include more than one slot, enclose

the slot numbers in braces.

For example, the following command configures slots 2, 3, and 4 to be eligible to

run the BGP soloist:

/jointfilesconvert/97454/bgp#

slot-mask {2 3 4}

/jointfilesconvert/97454/bgp#

Table 3-2. Slot Mask Parameter Values

Value Meaning

all-slots (default) The BGP soloist can run on all slots.

1 to 14 The BGP soloist can run only on the specified slots.

1 2 ... 55 56 57 58 59 60 61 62 63 64 65 ... 275 276

Žádné komentáře

Avaya Configuring IP Exterior Gateway Protocols (BGP and EGP) Uživatelský manuál Strana 60