Chapter 18 Testing basic Avaya BCM50 functionality 161
Installation and Maintenance Guide
Chapter 18
Testing basic Avaya BCM50 functionality
This section describes how to test the Avaya Business Communications Manager 50 (Avaya
BCM50) system.
For information about testing and troubleshooting the Avaya BCM50 system:
• To test the main unit on page 161
• To troubleshoot the main unit on page 162
• To test the expansion unit on page 162
• To troubleshoot the expansion unit on page 162
• To test the MBM on page 163
• To test a station MBM on page 163
• To test a trunk MBM on page 163
• To determine why an MBM does not appear in Business Element Manager on page 164
• To determine why the ATA2 does not function on page 164
• To determine why there is no dial tone at the ATA2 on page 164
• To check the ATA2 wiring on page 165
• Reset to factory settings on page 165
To test the main unit
If you have the digital station feature included in your installed keycode, use the following test to
ensure the main unit is operating properly:
1 Go to an extension that is connected to the RJ-21 telephony connector on the main unit.
2 Check for a dial tone.
3 Use this extension to make a call to another extension on the system.
4 If this system has an expansion unit with a media bay module (MBM) that supports
extensions, repeat steps 3 and 4 for an extension connected to the expansion unit.
5 Go to an extension that has access to one of the lines on the main unit.
6 Select the line or line pool to which the line belongs.
7 Check for a dial tone.
8 Make a call using the line or line pool.
9 If this system has an expansion unit with an MBM that supports lines, repeat steps 6 to 8 with
an extension that can access one of the lines connected to the expansion unit.
Komentáře k této Příručce