Avaya Configuring Dial Services Uživatelský manuál Strana 194

  • Stažení
  • Přidat do mých příruček
  • Tisk
  • Strana
    / 326
  • Tabulka s obsahem
  • KNIHY
  • Hodnocené. / 5. Na základě hodnocení zákazníků
Zobrazit stránku 193
Configuring Dial Services
8-30 114062 Rev. A
Circuit Group Protocol Parameters
Use the following descriptions as guidelines when you configure the parameters in
the Demand Circuit Groups window.
Parameter: IP Enable
Default: Disable
Options: Enable
| Disable
Function: Enables or disables IP on this interface.
Instructions: Select Enable to enable IP support on this interface.
MIB Object ID: 1.3.6.1.4.1.18.3.5.1.4.12.1.5
Parameter: Associated IP address
Default: None
Options: Any valid IP address
Function: Specifies an address that IP uses when sending out a packet. All circuits in
the demand circuit group use this address. This address is another
interface on the router for which you configured the unnumbered
interface. IP routing protocols use this address to advertise the local node
to remote nodes over the unnumbered interface. For more information
about associated IP addresses, refer to Configuring IP Services.
Instructions: Enter the address of any numbered interface on the router. If you are
running RIP over the unnumbered interface and if you are using a subnet
address as the associated address, the local and remote associated
addresses should have the same network number.
MIB Object ID: 1.3.6.1.4.1.18.3.5.1.4.12.1.6
Zobrazit stránku 193
1 2 ... 189 190 191 192 193 194 195 196 197 198 199 ... 325 326

Komentáře k této Příručce

Žádné komentáře