Avaya Configuring Dial Services Uživatelský manuál Strana 90
- Strana / 326
- Tabulka s obsahem
- KNIHY
Hodnocené. / 5. Na základě hodnocení zákazníků
Configuring Dial Services
5-6 114062 Rev. A
A router configured with demand circuit groups does not initiate connections for
the group; the remote side of the connection must place the call first.
Consequently, you do not need to configure the local PAP ID and password or
CHAP name and secret for a call request.
If, for added network security, each remote node has a unique PAP ID or CHAP
name and the same circuit group ID, the router verifies the caller’s name in the
incoming call setup message. If it does not match a name in the table, the router
disconnects the call.
Protocol Configuration for Demand Circuit Groups
You must configure a demand circuit group with one of the following unnumbered
protocols:
• IP with either RIP, RIP II, or OSPF as the routing protocol
• IPX with RIP, SAP, and/or NLSP as the routing protocol
• Bridging
The protocol configuration applies to all circuits in the group and applies to a list
of remote nodes that can call the recovery router.
Without the use of specific network addresses, the recovery router must use
routing updates to determine the data path to the remote nodes. Unlike individual
demand circuits, you can enable routing protocols for a demand circuit group
without the update protocol establishing a switched connection unnecessarily. The
demand circuit group and its protocol interface are active only when the physical
connection is active. Without a physical line available, no circuit or protocol
information, for example, RIP update packets, pass from one router to the next.
Note: The caller resolution table may not contain both individual demand
circuit numbers and demand circuit group IDs for the same caller name.
Note: When you configure a protocol for a demand circuit group, Site
Manager requires that you also configure a routing protocol.
- Configuring Dial 1
- Services 1
- Bay Networks Software License 3
- Contents 5
- 114062 Rev. A vii 7
- 114062 Rev. A ix 9
- 114062 Rev. A 10
- 114062 Rev. A xi 11
- 114062 Rev. A xiii 13
- 114062 Rev. A xv 15
- 114062 Rev. A xvii 17
- About This Guide 19
- Audience 20
- Before You Begin 20
- Conventions 21
- Acronyms 22
- 114062 Rev. A xxiii 23
- 114062 Rev. A xxv 25
- Bay Networks Customer Service 26
- World Wide Web 27
- Customer Service FTP 27
- Support Source CD 28
- CompuServe 28
- InfoFACTS 29
- How to Get Help 29
- Chapter 1 31
- Dial Services Overview 31
- DS0005A 32
- Dial-on-Demand Service 33
- Demand Lines and Pools 34
- 192.32.14.0 35
- 192.32.16.0 35
- Activating Demand Circuits 36
- Terminating Demand Circuits 38
- Dial Backup Service 39
- Primary Line 40
- Backup Line 40
- 1-12 114062 Rev. A 42
- Backup Lines and Pools 43
- 1-14 114062 Rev. A 44
- Activating the Backup Line 45
- 1-16 114062 Rev. A 46
- Bandwidth-on-Demand Service 47
- 1-18 114062 Rev. A 48
- Activating Secondary Lines 50
- Terminating Secondary Lines 50
- Chapter 2 53
- ISDN Overview 53
- ISDN Standards 54
- Primary Rate Interface 55
- The D Channel 55
- 2-4 114062 Rev. A 56
- Figure 2-3. LAPD Frame 56
- ISDN Interfaces 57
- Reference Points 58
- 2-8 114062 Rev. A 60
- Chapter 3 61
- Implementation Notes 61
- Types of Authentication 62
- 114062 Rev. A 3-3 63
- 3-4 114062 Rev. A 64
- Asynchronous PPP 66
- ISDN Services 68
- 114062 Rev. A 3-9 69
- 3-10 114062 Rev. A 70
- 114062 Rev. A 3-11 71
- 3-12 114062 Rev. A 72
- 114062 Rev. A 3-13 73
- Call Screening 74
- Rate Adaption 74
- Example 1 75
- Example 2 75
- 3-16 114062 Rev. A 76
- Chapter 4 77
- PPP Multilink 78
- Static Routes 79
- Traffic Filters 80
- Dial Optimized Routing 81
- 4-6 114062 Rev. A 82
- Protocol Prioritization 83
- Chapter 5 85
- Bandwidth for Backup Circuits 86
- 114062 Rev. A 5-3 87
- 5-4 114062 Rev. A 88
- 114062 Rev. A 5-5 89
- 5-6 114062 Rev. A 90
- 114062 Rev. A 5-7 91
- 5-8 114062 Rev. A 92
- Chapter 6 93
- 6-2 114062 Rev. A 94
- 6-4 114062 Rev. A 96
- 114062 Rev. A 6-5 97
- Chapter 7 99
- Caution: 100
- Pool ID Parameter 107
- Configuring Dial Services 108
- Creating Line Pools 109
- Adding Line Pools 110
- Configuring ISDN Lines 115
- PRI Physical Interfaces 117
- 7-20 114062 Rev. A 118
- 7-22 114062 Rev. A 120
- 7-24 114062 Rev. A 122
- 123
- 124
- 126
- 128
- 129
- 7-32 114062 Rev. A 130
- 131
- 7-34 114062 Rev. A 132
- 137
- 7-40 114062 Rev. A 138
- 7-42 114062 Rev. A 140
- Configuring ISDN Logical Lines 141
- 7-44 114062 Rev. A 142
- 7-46 114062 Rev. A 144
- 114062 Rev. A 7-47 145
- 7-48 114062 Rev. A 146
- 7-50 114062 Rev. A 148
- Local Phone Number Parameters 149
- 7-52 114062 Rev. A 150
- 114062 Rev. A 7-53 151
- Changing Pool IDs and Lines 153
- 114062 Rev. A 7-57 155
- 7-58 114062 Rev. A 156
- 114062 Rev. A 7-59 157
- 7-60 114062 Rev. A 158
- 114062 Rev. A 7-63 161
- 114062 Rev. A 7-65 163
- Chapter 8 165
- Configuring Demand Circuits 165
- Interface for Dialup Lines 167
- Demand Circuit Parameters 169
- Configuring Demand Circuits 171
- 184
- Deleting Demand Circuits 186
- 114062 Rev. A 8-23 187
- 8-24 114062 Rev. A 188
- 4. Click on OK to save 188
- 8-26 114062 Rev. A 190
- 8-28 114062 Rev. A 192
- 114062 Rev. A 8-29 193
- Chapter 9 197
- Configuring Backup Circuits 197
- Circuit Options Parameters 202
- Configuring Backup Circuits 205
- Interface Type Parameter 211
- 219
- 219
- 220
- 9-26 114062 Rev. A 222
- 9-28 114062 Rev. A 224
- 227
- 228
- 228
- 9-34 114062 Rev. A 230
- 114062 Rev. A 9-35 231
- (Figure 232
- Deleting Backup Circuits 234
- Chapter 10 235
- Congestion Monitor Parameters 247
- Deleting Bandwidth Circuits 255
- Chapter 11 257
- Configuring Phone Lists 257
- Configuring Phone Lists 263
- Chapter 12 273
- Configuring Caller Resolution 273
- Configuring Caller Resolution 277
- Appendix A 281
- Configuration Examples 281
- Dial-on-Demand Using PPP 282
- Table A-3. IP Parameters 284
- A-4 114062 Rev. A 284
- Phone List window 285
- A-6 114062 Rev. A 286
- Configuration of Router 1 287
- Configuration of Router 2 288
- Configuration Examples 289
- Table A-10. Demand Pools 289
- A-10 114062 Rev. A 290
- Table A-14. IP Parameters 291
- A-12 114062 Rev. A 292
- A-16 114062 Rev. A 296
- Table A-23. IP Parameters 297
- A-20 114062 Rev. A 300
- Table A-26. Backup Pools 300
- A-22 114062 Rev. A 302
- Appendix B 305
- B-4 114062 Rev. A 308
- B-6 114062 Rev. A 310
- B-8 114062 Rev. A 312
- Appendix C 313
- Ordering PRI Lines 314
- 114062 Rev. A Index-1 315
- 114062 Rev. A Index-3 317
- 114062 Rev. A Index-5 319
- 114062 Rev. A Index-7 321
- 114062 Rev. A Index-9 323
- 114062 Rev. A Index-11 325
Související produkty a manuály pro Softwarové příručky Avaya Configuring Dial Services
Softwarové příručky Avaya Business Communications Manager - LAN CTE Průvodce konfigurací
(28 stránky)
(28 stránky)
Softwarové příručky Avaya DMC DECT Fundamentals - Communications Server 1000 Uživatelský manuál
(340 stránky)
(340 stránky)
Softwarové příručky Avaya Configuring SNMP, BOOTP, DHCP, and RARP Services Uživatelský manuál
(108 stránky)
(108 stránky)
Softwarové příručky Avaya Nortel Business Communications Manager 450 1.0 Unified Messaging Průvodce konfigurací
(80 stránky)
(80 stránky)
© 2020, manymanuals.cz. Všechna práva vyhrazena. | 0.041 s |
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Komentáře k této Příručce