Avaya IP Telephony Průvodce konfigurací stáhnout pdf (Strana 48)

48 Chapter 3 Installing IP telephones

P0609327 02

Registering the telephone to the system

When you first connect the telephone to the IP connection, you may receive one of the following:

• If the telephone is not yet registered, and if a password was entered in the Terminal

Registration screen, the telephone prompts you for that password.

• If you set Auto Assign DN to OFF, the telephone prompts you for a DN. Refer to “Setting IP

terminal general settings” on page 43.

• If you are prompted for a password, enter the password and press OK

• If you are prompted for a DN, enter the DN you want assigned to this telephone and press OK

When the telephone registers, it downloads the information from the Business Communications

Manager IP Telephony record to the telephone configuration record. This might include a new

firmware download, which occurs automatically. If new firmware downloads, the telephone

display indicates the event.

Note: If the telephone displays a prompt that indicates it cannot find the server, follow the

instructions in “Configuring telephone settings” to enter the specific network path.

“Troubleshooting IP telephones” on page 51 describes other possible prompt messages.

After registration is complete, you do not need to go through the registration steps described above

unless you deregister the terminal. For information about setting the registration settings, see

“Setting IP terminal general settings” on page 43.

Configuring telephone settings

If you are not automatically registered to the Business Communications Manager, you can

configure your telephone settings to allow you to access a system on the network. You will also

need to perform these steps if your IP telephone is not connected to the same LAN to which the

Business Communications Manager is connected.

Follow these steps to access the local configuration menu on an i200X telephone:

1 Restart the telephone by disconnecting the power, then reconnecting the power.

After about four seconds, the top light flashes and

NORTEL NETWORKS appears on the screen.

2 When the greeting appears, immediately, and quickly, press the four display buttons, one

at a time, from left to right. These buttons are located directly under the display.

Display buttons

1 2 ... 43 44 45 46 47 48 49 50 51 52 53 ... 221 222

Žádné komentáře

Avaya IP Telephony Průvodce konfigurací Strana 48