Avaya IP Telephony Průvodce konfigurací Strana 91
- Strana / 222
- Tabulka s obsahem
- ŘEŠENÍ PROBLÉMŮ
- KNIHY
Hodnocené. / 5. Na základě hodnocení zákazníků
Chapter 5 Configuring local VoIP trunks 91
IP Telephony Configuration Guide
Setting up the local gateway
The call signaling method used by the local gateway defines how the Business Communications
Manager prefers call signaling information to be directed through VoIP trunks. Call signaling
establishes and disconnects a call. You set this information in the local gateway screens.
(“Modifying local gateway settings for H.323 and SIP trunks”)
If the network has a gatekeeper (H.323 trunks, only), The Business Communications Manager can
request a method for call signaling, but whether this request is granted depends on the
configuration of the gatekeeper. Ultimately, the gatekeeper decides which call signaling method to
use. Refer to “Using a gatekeeper” on page 133.
Jitter Buffer - Voice Auto
None
Small
Medium
Large
Select the size of jitter buffer you want to allow for your
system.
Refer to “Jitter Buffer” on page 28.
T.38 Fax Support Enabled
Disabled
Note: This field appears on H.323 screens only, as SIP
trunks do not support this feature.
Enabled: The system supports T.38 fax over IP.
Disabled: The system does not support T.38 fax over IP
CAUTION: Operations note: Fax tones that broadcast
through a telephone speaker will disrupt calls at other
telephones using VoIP trunks in the vicinity of the fax
machine. Here are some suggestions to minimize the
possibility of your VoIP calls being dropped because of fax
tone interference:
• Locate fax machine away from other telephones.
• Turn the speaker volume on the fax machine to the
lowest level, or off, if that option is available.
G.729 Payload Size
(ms)
10, 20, 30, 40, 50,
60
Default: 30
Set the maximum required payload size, per codec, for the
VoIP calls sent over H.323 trunks.
Note: Payload size can also be set for Nortel IP telephones.
Refer to “Setting IP terminal general settings” on page 43.
G.723 Payload Size
(ms)
30
G.711 Payload Size
(ms)
10, 20, 30, 40, 50,
60
Default:30
Table 22 Media parameters record (Continued)
Field Value Description
- Business Communications 1
- Manager 3.6 1
- IP Telephony Configuration 1
- Trademarks 2
- Contents 3
- Chapter 3 4
- Chapter 4 4
- Chapter 5 5
- 10 Contents 10
- P0609327 02 10
- Before you begin 15
- Symbols used in this guide 15
- Text conventions 16
- Acronyms 17
- Related publications 18
- How to get help 19
- 20 Preface 20
- Chapter 1 21
- Introduction 21
- IP telephones and VoIP trunks 22
- Figure 1 Network diagram 24
- Telephones 25
- Gatekeepers on the network 25
- IP network 26
- Key IP telephony concepts 27
- Jitter Buffer 28
- QoS routing 29
- Chapter 2 31
- Prerequisites checklist 31
- Network devices 32
- Network assessment 33
- Resource assessment 33
- Keycodes 34
- Option Description 35
- VoIP trunks 39
- IP telephone records 40
- Installing IP telephones 41
- Choosing a codec 45
- Choosing a Jitter Buffer 46
- Before installing 46
- Using a 3-port switch 46
- Display buttons 48
- Troubleshooting IP telephones 51
- Operation issues 52
- Configuring DHCP 53
- IP telephony DHCP notes 54
- Checking IP server status 56
- Figure 7 IP Terminal status 57
- Notes about Hot Desking 62
- Customizing feature labels 63
- Moving IP telephones 69
- Figure 16 i2050 Switch type 72
- Handset and call functions 74
- Configuring NetVision records 75
- Assigning general settings 76
- Changing a handset Name 82
- Deregistering a telephone 83
- Configuring local VoIP trunks 85
- Published IP address 86
- Counting IP trunks 87
- Configuring media parameters 89
- Setting up the local gateway 91
- How to use target lines 98
- Configuring target lines 99
- Chapter 6 101
- Field Value Description 104
- 6 Click the Save button 105
- Outgoing call configuration 107
- H.323 trunks 108
- SIP trunks 108
- Keycodes: 2 108
- PSTN call to remote node 109
- Call process 110
- Describing a fallback network 113
- Adding routes for fallback 114
- Figure 35 Route XXX screen 115
- Figure 36 VoIP schedule 117
- How fallback routing works 120
- Settings for 124
- Santa Clara 124
- Connecting an i200X telephone 125
- PSTN fallback metrics 126
- Quality of Service Monitor 127
- Updating the QoS monitor data 128
- Chapter 7 129
- 3 Enter the port settings 130
- Modifying PortRanges 131
- Using a gatekeeper 133
- 8 Click Submit 140
- Gatekeeper call scenarios 141
- Faxing over VoIP lines 142
- Chapter 8 147
- WarehouseHead Office 148
- Appendix A 153
- Efficient Networking 153
- Network engineering 154
- LAN engineering examples 157
- WAN engineering 158
- Setting Non-linear processing 159
- Enough link capacity 161
- Further network analysis 162
- Components of delay 163
- Reduce link delay 163
- Reducing hop count 164
- Adjust the jitter buffer size 164
- Reduce packet errors 164
- Routing issues 165
- Appendix B 167
- Silence compression 167
- Time -> 169
- Bandwidth -> 169
- Channel/Link Max 169
- Comfort noise 172
- Appendix C 173
- Network performance utilities 173
- Appendix D 175
- Interoperability 175
- Speech path setup methods 176
- Media path redirection 177
- Gatekeeper 177
- No feedback busy station 178
- Interoperability 179 179
- 180 Interoperability 180
- Using VLAN on the network 181
- 182 Interoperability 182
- Symbol NetVision telephones 183
- 184 Interoperability 184
- Interoperability 185 185
- 186 Interoperability 186
- Interoperability 187 187
- 188 Interoperability 188
- Interoperability 189 189
- 190 Interoperability 190
- Appendix E 191
- Quality of Service 191
- 192 Quality of Service 192
- Measuring Intranet QoS 193
- Recording routes 194
- Adjusting Ping measurements 195
- Measurement procedure 196
- Quality of Service 197 197
- Traffic mix 198
- TCP traffic behavior 199
- Network Quality of Service 200
- Quality of Service parameters 201
- Fallback to PSTN 201
- 202 Quality of Service 202
- Glossary 203
- 204 Glossary 204
- Glossary 205 205
- 206 Glossary 206
- Glossary 207 207
- 208 Glossary 208
- Glossary 209 209
- 210 Glossary 210
- 222 Index 222
Související produkty a manuály pro Softwarové příručky Avaya IP Telephony
Softwarové příručky Avaya Router Rychlý návod
(132 stránky)
(132 stránky)
Softwarové příručky Avaya BCM450 Instalační manuál
(74 stránky)
(74 stránky)
Softwarové příručky Avaya Configuring SNMP, RMON, BOOTP, DHCP, and RARP Services Uživatelský manuál
(130 stránky)
(130 stránky)
Softwarové příručky Avaya LT2P Uživatelský manuál
(76 stránky)
(76 stránky)
© 2020, manymanuals.cz. Všechna práva vyhrazena. | 0.035 s |
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Komentáře k této Příručce