Avaya Configuring and Managing Routers with Site Manager Uživatelský manuál stáhnout pdf (Strana 116)

Configuring and Managing Routers with Site Manager

3-20

309081-14.20 Rev 00

To select WAN protocols for a circuit:

Click on the box to the left of the protocols you want to enable, then click

on OK.

When you select a WAN protocol, note the following:

• Selecting frame relay, point-to-point protocol (PPP), or switched

multimegabit data service (SMDS) automatically enables protocol

prioritization. For information about protocol prioritization, see

Configuring Traffic Filters and Protocol Prioritization.

• If you select Nortel Networks Standard protocol, you cannot change the

WAN protocol on this circuit to any other protocol. If you want to enable

another protocol on this circuit, you must delete the circuit and create a

new one. For instructions on deleting a circuit from the router, see

“Deleting a Circuit from the Router” on page 3-29

• When you enable a WAN protocol, the synchronous line parameters are

automatically set to the following values.

See Configuring WAN Line Services for more information.

• If you are configuring the COM2 port on an AN or ANH router, the Edit

ASYNC Parameters window opens. See Configuring WAN Line Services

for information about this window.

2. After you choose a WAN protocol, do one of the following:

• Select a LAN protocol for this circuit, if prompted by the Configuration

Manager.

Parameter Setting

BOFL Disable

Promiscuous Enable

Service Transparent

WAN Protocol WAN protocol you enabled

1 2 ... 111 112 113 114 115 116 117 118 119 120 121 ... 385 386

Žádné komentáře

Avaya Configuring and Managing Routers with Site Manager Uživatelský manuál Strana 116