
Using Technician Interface Scripts
2-300 117380-A Rev. A
Sample Display - show fr lines
$show fr lines
Line.LLIndex Circuit Mgt Type Intf Type Status Faults Discard Drop
---------------- -------- --------- --------- -------- ------ -------- ------
201301.0 S131 AnnexD Primary Running 0 0 0
1000201301.0 Unknown AnnexD Backup/Sh NotPres 0 0 0
2 entry(s) found
The table includes the following information:
Line.LLIndex.DLCI Line or instance identifier for the interface plus the PVC identifier
(DLCI).
State State of the virtual circuit as follows:
• Invalid - Circuit is configured but the switch has not confirmed it.
• Active - Circuit is usable.
• Inactive - Circuit is configured but not active.
Type Way the virtual circuit was created:
• Static - User manually configured the PVC.
• Dynamic - PVC was created during operations.
Mode Operational mode of the PVC, as follows:
• Direct - Upper-layer protocols view this PVC as a point-to-point
connection; as an individual network interface.
• Group - Upper-layer protocols treat this PVC as one of a group of
destinations to the switched network. The upper-layer protocols
use a single network address to send all traffic destined for the
switched network to the frame relay network interface.
• Hybrid - Allows protocols to view this PVC as part of the group
while the bridge views the PVC in direct mode.
Congestion Status of the congestion control mechanisms: Disabled, Enabled,
or Inherit. Inherit indicates that the VC uses the parameters from
the DLCMI record.
Serv Circuit number of the PVC, unless this is a hybrid circuit. If this is
a hybrid circuit, Serv is the Circuit number of the group.
Circuit Name of the frame relay circuit for the PVC unless the circuit is
hybrid. If this is a hybrid circuit, Circuit is the name of the hybrid
circuit.
Komentáře k této Příručce