
Using Technician Interface Scripts
2-626 117380-A Rev. A
Sample Display - show sync alerts
SYNC Modules on Alert:
----------------------
Line WAN Loc Rem Med
Slot Conn Circuit State MAC Address Number MTU Protocol Adr Adr Typ
---- ---- ------- -------- ----------------- -------- ---- -------- --- --- ---
2 1 T1-21 Down 00-00-A2-00-B6-1B 00302101 1600 WF STND 7 7 T1
2 2 T1-22 Down 00-00-A2-00-B6-1C 00302102 1600 WF STND 7 7 T1
Found 2 matches out of 4 entries in table.
WAN Protocol WAN protocol enabled on this interface, as follows:
• ATM - Asynchronous Transfer Mode protocol
• FRM RLAY - Frame Relay protocol
• PASSTHRU - Interface passes data through the network to a
SYNC interface configured for Pass Thru on another Bay
Networks router. IBM sites typically use this protocol to pass
proprietary SYNC data through a Bay Networks network.
• PPP - Point-to-Point Protocol
• SMDS - Switched Multi-Megabit Data Service protocol
• WF STND - Wellfleet Standard, a proprietary protocol used
between two Bay Networks routers. Based on the CCITT HDLC
(High-level Data Link Control) protocol, Wellfleet Standard
provides LLC1 (connectionless, datagram) service. This protocol
is sometimes referred to as Wellfleet Point-to-Point.
• X.25 - X.25 protocol
Loc Adr 1-byte value, used in the address field of the HDLC packet. It may
be extended to two octets if the
<circuit_name>
Extended Address
parameter is enabled. The values are DTE, DCE, and Explicit.
Rem Adr 1-byte value, used in the address field of the HDLC packet. It may
be extended to two octets if the Extended Address parameter is
enabled. The values are DTE, DCE, and Explicit.
Med Typ Media type this SYNC module uses, as follows:
• STD - Normal connection.
• T1 - T1 lines.
• E1 - E1 lines.
• DTR - Connection to a modem that dials out when Data Terminal
Ready (DTR) gets raised.
• V25 - Connection to a V25 BIS modem.
Komentáře k této Příručce