Avaya Business Policy Switch 2000 Command Line Interface Release 2.0 Uživatelský manuál stáhnout pdf (Strana 203)

Chapter 6 Policy-enabled networks and QoS 201

Reference for the Business Policy Switch 2000 Command Line Interface

qos l2-filter command

The qos l2-filter command adds and deletes layer 2 (L2) filters. The syntax

for the

qos l2-filter command is:

qos l2-filter <fid> {create [ethertype <etype>]

[vlan <vidlist>] [vlan-tag <vtag>] [priority <ieee1p-seq>]

[ds-field <dscp>] [protocol <protocoltype>] [src-port-min

dst-port-max <port>]|delete}

The qos l2-filter command is in the config mode.

Table 118 describes the parameters and variables for the

qos l2-filter

command.

Note: You must define the filter before adding it to a filter set.

You cannot delete an IP filter set that is referenced in an installed policy.

You cannot delete the last IP filter in an IP filter set that is referenced in

an installed policy.

Note: Beginning with software version 2.0, you can reference up to 32

VLANs with a single layer 2 filter.

Table 118 qos l2-filter command parameters and variables

Parameters and variables Description

<fid> Enter an integer to specify the filter ID; range is 1 to

65535.

create Defines a new L2 filter with the specified filter ID.

ethertype <etype> Enter the Ethernet type in the form of 0xXXXX, for

example, 0x0801.

Default is ignore.

1 2 ... 198 199 200 201 202 203 204 205 206 207 208 ... 232 233

Žádné komentáře

Avaya Business Policy Switch 2000 Command Line Interface Release 2.0 Uživatelský manuál Strana 203