Avaya Business Policy Switch 2000 Command Line Interface Release 2.0 Uživatelský manuál Strana 77

  • Stažení
  • Přidat do mých příruček
  • Tisk
  • Strana
    / 233
  • Tabulka s obsahem
  • KNIHY
  • Hodnocené. / 5. Na základě hodnocení zákazníků
Zobrazit stránku 76
Chapter 2 General CLI commands 75
Reference for the Business Policy Switch 2000 Command Line Interface
web-server
The web-server command enables or disables the Web server that you use for
Web-based management. The syntax for the
web-server command is:
web-server {enable|disable}
The web-server command is in the config mode
Table 22 describes the parameters and variables for the
web-server command.
no web-server
The no web-server command disables the Web server that you use for
Web-based management. The syntax for the
no web-server command is:
no web-server
The no web-server command is in the config mode.
The
no web-server command has no parameters or values.
Setting boot parameters
You can reboot the switch or stack and configure BootP. The topics covered in this
section are:
boot command, next
ip bootp server command on page 77
Table 22 web-server command parameters and variables
Parameters and
variables
Description
enable|disable Enables or disables the Web server.
Zobrazit stránku 76
1 2 ... 72 73 74 75 76 77 78 79 80 81 82 ... 232 233

Komentáře k této Příručce

Žádné komentáře