Avaya Business Policy Switch 2000 Command Line Interface Release 2.0 Uživatelský manuál stáhnout pdf (Strana 208)

206 Chapter 6 Policy-enabled networks and QoS

212160-B

The qos meter command is in the config command mode.

Table 121 describes the parameters and variables for the

qos meter command.

Configuring QoS shapers

Table 121 qos meter command parameters and variables

Parameters and variables Description

<metid> Enter an integer to specify the QoS meter; range is 1 to 65535.

name <metname> Assigns a name to the QoS meter with the designated meter ID. Enter name

for meter; maximum is 16 alphanumeric characters.

committed-rate <rate> Specifies rate that traffic must not exceed for extended periods to be

considered in-profile. Enter the rate in Kb/s for in-profile traffic; range is 1 to

65535 Kb/s.

max-burst-rate <burstrate> Specifies the largest burst of traffic that can be received a given time for the

traffic to be considered in-profile. Used in calculating the committed burst

size. Enter the burst size in Kb/s for in-profile traffic; range is 1 to 65535

Kb/s

max-burst-duration

Specifies the amount of time that the largest burst of traffic that can be

received for the traffic to be considered in-profile. Used in calculating the

committed burst size. Enter the burst duration in ms for in-profile traffic;

range is 1 to 65535 ms.

delete Deletes the specified meter.

You cannot delete a meter that is referenced in an installed policy.

Note: You must be using either the BPS2000-1GT, BPS2000-2GT, or

BPS2000-2GE MDA in order to implement the QoS shaping features.

1 2 ... 203 204 205 206 207 208 209 210 211 212 213 ... 232 233

Žádné komentáře

Avaya Business Policy Switch 2000 Command Line Interface Release 2.0 Uživatelský manuál Strana 208