Avaya Business Policy Switch 2000 Command Line Interface Release 2.0 Uživatelský manuál stáhnout pdf (Strana 207)

Chapter 6 Policy-enabled networks and QoS 205

Reference for the Business Policy Switch 2000 Command Line Interface

Configuring QoS meters

Using the CLI, you set meters. If you want to meter, or police, the traffic,

configure the committed rate, burst rate, and burst duration. If you are not

metering data, skip this page.

qos meter command

The qos meter command creates or deletes a QoS meter. The syntax for the qos

meter

command is:

qos meter <metid> {create [name <metname>] committed-rate

<rate> max-burst-rate <burstrate> [max-burst-duration

<burstdur>]|delete}

update-1p Specifies whether 802.1p priority value should be updated or left

unchanged; unchanged equals ignore:

• ieee1p—enter the value you want; range is 0 to 7

• default—allows the value to be derived based on assignment of

other action parameters

• use-egress-map—uses the egress map to assign value

Default is default.

set-drop-prec

{loss-sensitive|not-

loss-sensitive|

default|use-egress

-map}

Enter the loss-sensitivity value you want:

• loss-sensitive

• not-loss-sensitive

• default

• use-egress-map

Default is use default.

Note: Certain options may be restricted based on the policy associated

with the specific action.

You cannot delete an action that is referenced in an installed policy.

Table 120 qos action command parameters and variables (continued)

Parameters and

variables

Description

1 2 ... 202 203 204 205 206 207 208 209 210 211 212 ... 232 233

Žádné komentáře

Avaya Business Policy Switch 2000 Command Line Interface Release 2.0 Uživatelský manuál Strana 207