Avaya Business Policy Switch 2000 Command Line Interface Release 2.0 Uživatelský manuál Strana 94

  • Stažení
  • Přidat do mých příruček
  • Tisk
  • Strana
    / 233
  • Tabulka s obsahem
  • KNIHY
  • Hodnocené. / 5. Na základě hodnocení zákazníků
Zobrazit stránku 93
92 Chapter 2 General CLI commands
212160-B
no snmp-server command
The no snmp-server command disables SNMP or clears the configuration. If
you omit the parameters, this command disables SNMP access. The syntax for the
no snmp-server command is:
no snmp-server [authentication-trap|community [ro|rw]
contact|host [<host-ip> <community-string>]|location |name]
The no snmp-server command is in the config command mode.
Table 33 describes the parameters and variables for the
snmp-server command.
Table 33 no snmp-server command parameters and variables
Parameters and variables Description
enable|disable With no parameters, disables SNMP access.
authentication-trap Disables authentication failure traps.
community Disables the community string.
ro|rw Disables either read-only or read-write access.
contact <text> Clears the SNMP sysContact value.
host <host-ip> <community-string> Removes an SNMP trap destination or all destinations.
location Clears the SNMP sysLocation value.
name Clears the SNMP sysName value
Note: Disabling SNMP access will also lock you out of the DM
management system.
Zobrazit stránku 93
1 2 ... 89 90 91 92 93 94 95 96 97 98 99 ... 232 233

Komentáře k této Příručce

Žádné komentáře