Avaya Using Technician Interface Software Uživatelský manuál stáhnout pdf (Strana 154)

Using Technician Interface Software

8-2

• Conﬁgure search depth for hardware compression

• Display a greeting or message before the login prompt

• Customize the Technician Interface Welcome message

• Record console messages to a ﬁle

• Enable Internal Clocking Mode

• Respond to QENET Underﬂow Errors

• Monitor IP routes (for IP, OSPF, BGP)

A table of all the Technician Interface commands and their associated access

levels appears at the end of this chapter (Table 8-4).

AN/ANH/ASN Administration

The following sections apply to the Access Node (AN), Access Node Hub (ANH),

and Access Stack Node (ASN) routers. The following guides collectively provide

complete instructions for setting up netboot and directed netboot on an AN, ANH,

or ASN router:

• Installing and Starting BayStack AN Routers

• Installing and Starting 8-Port BayStack ANH Systems

• Installing and Maintaining ASN Routers and BNX Platforms

• Connecting BayStack AN and ANH Systems to a Network

• Connecting ASN Routers and BNX Platforms to a Network

You need to use the

ifconﬁg and bconﬁg commands to conﬁgure the AN, ANH,

and ASN:

• Use the

ifconﬁg command to conﬁgure the router’s initial IP interface to the

network.

• Use the

bconﬁg command to specify the location and name of the router’s

software image and conﬁguration ﬁle.

1 2 ... 149 150 151 152 153 154 155 156 157 158 159 ... 351 352

Žádné komentáře

Avaya Using Technician Interface Software Uživatelský manuál Strana 154