Avaya Using Technician Interface Software Uživatelský manuál stáhnout pdf (Strana 264)

Using Technician Interface Software

B-2

This section describes

• The asynchronous terminal program available on UNIX and

386/486 DOS remote workstations

• The Technician Interface

xmodem command, its parameters, and its options

• How you use the asynchronous terminal program and

xmodem commands

together in procedures for transferring ﬁles to and from Bay Networks routers

About xmodem

Bay Networks routers support xmodem as a Technician Interface command and a

set of protocols for moving ﬁles between the Technician Interface console port of

a router and a remote workstation.

xmodem is based on the Christensen protocol

ﬁle transfer utility, V3.9, November 1990.

You determine the protocol for the task you need to perform by selecting the

appropriate syntax (parameters and options) for each

xmodem command. You

enter

xmodem commands directly at the command line prompt of either a UNIX

workstation or a 386/486 DOS workstation. (The procedural information you

need to enter and use

xmodem commands follows later in this appendix.)

As a set of protocols,

xmodem includes the

• XMODEM/CRC protocol

• MODEM7 batch protocol

• XMODEM-1K block protocol

• YMODEM batch protocol

Of the four protocols available through

xmodem commands, you need to use only

the YMODEM batch protocol to transfer Bay Networks ﬁles between a remote

workstation and a router. For this reason, this section covers information on the

YMODEM protocol only. (For information on the other protocols supported by

xmodem commands, refer to “For More Information,” later in this appendix.)

1 2 ... 259 260 261 262 263 264 265 266 267 268 269 ... 351 352

Žádné komentáře

Avaya Using Technician Interface Software Uživatelský manuál Strana 264