Avaya Using Technician Interface Software Uživatelský manuál stáhnout pdf (Strana 179)

100

101

System Administration

8-27

We recommend that you issue the diags command to the associated slot

immediately after you hot-swap a board. Otherwise, the DIAG LED on the front

panel and LED 8 on the FRE module remain on, indicating that diagnostics have

not been run on the ILI. (Refer to the Installing and Maintaining BN Routers

manual for more information.) If the board is functional, and you do not issue the

diags command, the processor module automatically boots, loads the

conﬁguration, starts the router software services, and operates normally, although

the DIAGS LED remains lit.

When you issue the

diags or diags

<slot_no.>

commands from a local console

rather than from a Telnet session, the results depend on

• The slot number you designate in the command line

• The slot number from which you issue the command

• The model of Bay Networks router

• The type of router (single-slot or multislot)

Based on these variables, the router system or slot performs a restart, a warm-

boot, or a cold-boot operation. The following table describes the different

responses:

1 2 ... 174 175 176 177 178 179 180 181 182 183 184 ... 351 352

Komentáře k této Příručce

Žádné komentáře

Avaya Using Technician Interface Software Uživatelský manuál Strana 179

Komentáře k této Příručce

Související produkty a manuály pro Software Avaya Using Technician Interface Software