Avaya Using Technician Interface Software Uživatelský manuál stáhnout pdf (Strana 314)

Using Technician Interface Software

C-20

To deﬁne by severity levels the event messages you want Syslog to select

and forward to a speciﬁc remote host, enter the following:

$: set wfSyslogEntFltrEntry.wfSyslogEntFltrSevMask.

<host_IP_address>.<entity_code>.<ﬁlter_index>

“

<fwitd>”

$: commit

c. To also deﬁne by slot number(s) the event messages you want Syslog

to select and forward to a speciﬁc remote host, enter the following:

$: set wfSyslogEntFltrEntry.wfSyslogEntFltrSlotLowBnd.

<host_IP_address>.<entity_code>.<ﬁlter_index>

<0 – 14>

$: set wfSyslogEntFltrEntry.wfSyslogEntFltrSlotLowUpp.

<host_IP_address>.<entity_code>.<ﬁlter_index>

<0 – 14>

$: commit

3. Deﬁne how router event message severity levels and UNIX system error

levels map to one another.

In most cases, you accept the default mapping and go to Task 7. Otherwise,

continue with the following instructions to customize the message mapping.

Enter at the Technician Interface prompt the command line(s) appropriate for

the message mapping(s) you want to change:

a. Change router FAULT message mapping, as follows:

$: set wfSyslogEntFltrEntry.wfSyslogEntFltrFaultMap.

<host_IP_address>

<entity_code>

<ﬁlter_index>

<1 – 8>

The default value of wfSyslogEntFltrFaultMap is 3, mapping router

FAULT level messages to UNIX system level CRIT messages.

Note: Although the valid range for the slot lower and upper boundaries is 0 to

14, specify only values within the range of actual slot numbers for the model of

router you are conﬁguring. Otherwise, the ﬁlter will not transition to an active

state.

1 2 ... 309 310 311 312 313 314 315 316 317 318 319 ... 351 352

Žádné komentáře

Avaya Using Technician Interface Software Uživatelský manuál Strana 314