Avaya Reference for the Business Policy Switch 2000 Command Line Interface Release 1.2 Uživatelský manuál stáhnout pdf (Strana 130)

130 Chapter 4 Spanning Tree, MLT, and Port-Mirroring

212160-A

default spanning-tree command by port

The default spanning-tree command by port sets the spanning tree values

for the ports within the specified spanning tree group to the factory default

settings. The syntax for the

default spanning-tree command by port is:

default spanning-tree [port <portnum>] [stp <1-8>]

[learning] [cost] [priority]

The default spanning-tree command by port is in the config-if command

mode.

Table 72 describes the parameters and variables for the

default

spanning-tree command by port.

Table 71 spanning-tree command by port parameters and variables

Parameters and

variables

Description

port <portnum> Enables spanning tree for the specified port or ports; enter port

or ports you want enabled for spanning tree.

Note: If you omit this parameter, the system uses the port

number you specified when you issued the interface

command.

stp <1-8> Specifies the spanning tree group you want; enter the STG ID.

learning

{disable|normal|fast}

Specifies the STP learning mode:

• disable—disables FastLearn mode

• normal—changes to normal learning mode

• fast—enables FastLearn mode

cost <1-65535> Enter the path cost of the spanning tree; range is 1-.65535.

priority <0-255> Enter the priority value of the spanning tree; range is 0-255.

1 2 ... 125 126 127 128 129 130 131 132 133 134 135 ... 199 200

Žádné komentáře

Avaya Reference for the Business Policy Switch 2000 Command Line Interface Release 1.2 Uživatelský manuál Strana 130