Avaya Reference for the Business Policy Switch 2000 Command Line Interface Release 1.2 Uživatelský manuál stáhnout pdf (Strana 89)

Chapter 2 General CLI commands 89

Reference for the Business Policy Switch 2000 Command Line Interface

Setting port speed

You can set the speed and duplex mode for a port. This section covers:

• “speed command,” next

• “default speed command” on page 90

• “duplex command” on page 90

• “default duplex command” on page 91

speed command

The speed command sets the speed of the port. The syntax for the speed

command is:

speed [port <portnum|all>] {10|100|1000|auto}

The speed command is in the config-if command mode.

Table 38 describes the parameters and variables for the

speed command.

Table 38 speed command parameters and variables

Parameters and

variables

Description

port <portnum|all> Specifies the port number to configure the speed. Enter the port

number you want to configure, or all to configure all ports

simultaneously.

Note: If you omit this parameter, the system uses the port number

you specified in the

interface command.

10|100|1000|auto Sets speed to:

• 10—10 Mb/s

• 100—100 Mb/s

• 1000—1000 Mb/s or 1 GB/s

• auto—autonegotiation

1 2 ... 84 85 86 87 88 89 90 91 92 93 94 ... 199 200

Žádné komentáře

Avaya Reference for the Business Policy Switch 2000 Command Line Interface Release 1.2 Uživatelský manuál Strana 89