
144 Chapter 5 VLANs and IGMP
212160-A
The vlan create command allows you to create a VLAN. You create a VLAN
by setting the state of a previously non-existent VLAN.
The syntax for the
vlan create command is:
vlan create <1-4094>] [name <line>] [learning {IVL|SVL}]
type
{macsa|
port|
protocol-ipEther2|
protocol-ipx802.3|
protocol-ipx802.2|
protocol-ipxSnap|
protocol-ipxEther2|
protocol-ApltkEther2Snap|
protocol-decEther2|
protocol-decOtherEther2|
protocol-sna802.2|
protocol-snaEther2|
protocol-Netbios|
protocol-xnsEther2|
protocol-vinesEther2|
protocol-ipv6Ether2|
protocol-Userdef <4096-65534>|
protocol-RarpEther2|
[IVL|SVL]}
The vlan create command is in the config command mode.
Table 80 describes the parameters and variables for the
vlan create command.
Note: With software version 1.2, you can configure as many as 255
protocol-based VLANs, with up to 14 different protocols.
Table 80 vlan create command parameters and variables
Parameters and variables Description
<1-4094> Enter the number of the VLAN to create.
name <line> Enter the name of the VLAN to create.
Komentáře k této Příručce