
62 Chapter 2 General CLI commands
212160-A
Table 15 describes the parameters and variables for the ip default-gateway
command.
no ip default-gateway command
The no ip default-gateway command sets the IP default gateway address to
zeros (0). The syntax for the
no ip default-gateway command is:
no ip default-gateway
The no ip default-gateway command is in the config command mode.
The
no ip default-gateway command has no parameters or variables.
Table 15 ip default-gateway command parameters and variables
Parameters and
variables
Description
XXX.XXX.XXX.XXX Enter the dotted-decimal IP address of the default IP gateway.
Note: When you change the IP gateway, you may lose connection to
Telnet and the Web.
Note: When you change the IP gateway address, you may lose
connection to Telnet and the Web.You also may disable any new Telnet
connection be required to connect to the serial console port to configure
a new IP gateway address.
Komentáře k této Příručce