Avaya Reference for the Business Policy Switch 2000 Command Line Interface Release 1.2 Uživatelský manuál stáhnout pdf (Strana 180)

180 Chapter 6 Policy-enabled networks and QoS

212160-A

Configuring QoS actions

You can configure QoS actions, which directs the BPS 2000 to take specific action

on each packet, using the CLI.

qos action command

The qos action command creates or deletes a QoS action. The syntax for the

qos action command is:

qos action <actid> [name <actname>] [drop-action

{enable|disable}] [update-dscp <dscp>] [update-1p

{<ieee1p>|default|use-egress-map}] [set-drop-prec

{loss-sensitive|not-loss-sensitive|default|use-egress-map}]

The qos action command is in the config mode.

Table 105 describes the parameters and variables for the

qos action command.

Table 105 qos action command parameters and variables

Parameters and

variables

Description

<actid> Enter an integer to specify the QoS action; range is 1 to 65535.

name <actname> Assigns a name to a QoS action with the designated action ID. Enter

the name for the action; maximum is 16 alphanumeric characters

drop-action

{enable|disable}

Specifies whether packets should be dropped or not; the drop action

equals enable.

Default is disable.

update-dscp

<dscp>

Specifies whether DSCP value should be updated or left unchanged;

unchanged equals ignore. Enter the 6-bit DSCP value you want;

range is 0 to 63.

Default is ignore.

1 2 ... 175 176 177 178 179 180 181 182 183 184 185 ... 199 200

Žádné komentáře

Avaya Reference for the Business Policy Switch 2000 Command Line Interface Release 1.2 Uživatelský manuál Strana 180