
Chapter 4 Spanning Tree, MLT, and Port-Mirroring 135
Reference for the Business Policy Switch 2000 Command Line Interface
Using port-mirroring
You use port-mirroring to monitor traffic. Refer to Using the Business Policy
Switch 2000 Software Version 1.2 for configuration guidelines for port-mirroring.
This section covers the following commands:
• “show port-mirroring command,” next
• “port-mirroring command” on page 135
• “no port-mirroring command” on page 137
show port-mirroring command
The show port-mirroring command displays the port-mirroring
configuration. The syntax for the
show port-mirroring command is:
show port-mirroring
The show port-mirroring command is in the privExec command mode.
The
show port-mirroring command has no parameters or variables.
Figure 27 displays sample output from the
show port-mirroring command.
Figure 27 show port-mirroring command output
port-mirroring command
The port-mirroring command sets the port-mirroring configuration. The
syntax of the
port-mirroring command is:
BPS2000(config)#show port-mirroring
Monitoring Mode: Xrx ( -> Port X )
Monitor Port: 1/3
Port X: 1/1
Komentáře k této Příručce