
96 Chapter 2 General CLI commands
212160-A
Enabling rate-limiting
You can limit the percentage of multicast traffic, or broadcast traffic, or both using
the CLI. For more information on rate-limiting, refer to Using the Business Policy
Switch 2000 Software Version 1.2.
This section covers:
• “show rate-limit command,” next
• “rate-limit command” on page 97
• “no rate-limit command” on page 98
• “default rate-limit command” on page 99
show rate-limit command
The show rate-limit command displays the rate-limiting settings and
statistics. The syntax for the
show rate-limit command is:
show rate-limit
The show rate-limit command is in the privExec command mode.
The
show rate-limit command has no parameters or variables.
Figure 20 displays sample output from the
show rate-limit command.
Komentáře k této Příručce