Avaya Reference for the Business Policy Switch 2000 Command Line Interface Release 1.2 Uživatelský manuál stáhnout pdf (Strana 58)

58 Chapter 2 General CLI commands

212160-A

configure network [load-on-boot

{disable|use-bootp|use-config}] [filename <WORD>] [address

<XXX.XXX.XXX.XXX>]

The configure network command is in the exec mode.

Table 12 describes the parameters and variables for the

configure network

command.

Note: When you enter configure network with no parameters, the

system prompts you for the script file name and TFTP server address and

then downloads the script.

Table 12 configure network command parameters and variables

Parameters and variables Description

load-on-boot

{disable|use-bootp|use-config

Specifies the settings for automatically loading a configuration file when

the system boots:

• disable—disables the automatic loading of config file

• use-boot—specifies using the BootP file as the automatically loaded

config file

• use-config—specifies using the ASCII configuration file as the

automatically loaded config file

Note: If you omit this parameter, the system immediately downloads and

runs the ASCII config file.

filename <WORD> Specifies the file name.

Note: If you omit this parameter and do not specify BootP, the system

uses the configured file name.

address <XXX.XXX.XXX.XXX> Specifies the TFTP server from which to load the file. Enter the IP

address in dotted-decimal notation.

Note: If you omit this parameter and do not specify BootP, the system

uses the configured address.

1 2 ... 53 54 55 56 57 58 59 60 61 62 63 ... 199 200

Žádné komentáře

Avaya Reference for the Business Policy Switch 2000 Command Line Interface Release 1.2 Uživatelský manuál Strana 58