
Chapter 2 General CLI commands 99
Reference for the Business Policy Switch 2000 Command Line Interface
default rate-limit command
The default rate-limit command restores the rate-limiting value for the
specified port to the default setting. The syntax for the
default rate-limit
command is:
default rate-limit [port <portnum>]
The default rate-limit command is in the config-if command mode.
Table 47 describes the parameters and variables for the
default rate-limit
command.
Table 47 default rate-limit command parameters and variables
Parameters and
variables
Description
port <portnum> Specifies the port number to reset rate-limiting to factory default.
Enter the port number you want to set rate-limiting to default on.
Note: If you omit this parameter, the system uses the port number
you specified in the
interface command.
Komentáře k této Příručce