Avaya BCM 4.0 Networking Průvodce konfigurací stáhnout pdf (Strana 225)

100

101

Chapter 19 BRI ISDN: BRI T-loops 225

BCM 4.0 Networking Configuration Guide

Configuring BRI T-loop parameters

To configure BRI T-loop parameters

1 Identify the loop as a T-loop (refer to “Configure loop type and general parameters” on

page 233).

• Protocol (ETSI and ETSI-QSIG loops, only)

• ONN block state

• Overlap receiving

• Overlap length

• Send name display (ETSI-QSIG only)

2 Enter the details for the loop (refer to “T-loop SPIDS and network DNs” on page 235).

North American systems only:

•SPID

• B-channel

•Network DN

• Call type

ETSI and ETSI-QSIG T-loops (UK profile)

• Clock source

3 If applicable, configure D-packet service for the loop (refer to “T-loops D-packet service” on

page 237).

4 Provision the loop and the loop lines (refer to “Provisioning module lines/loops” on page 132).

5 Program the BRI lines (refer to “Configuring BRI lines” on page 225). If the lines are set to

auto-answer, put the lines into line pools (A to O) and configure target lines.

6 Assign the lines/line pools and target lines to the telephones. Refer to Line Access - Line

Assignment tab and Line Access - Line Pool Access tab in the BCM 4.0 Device Configuration

Guide (N0060600).

Configuring BRI lines

There are two lines for every ISDN BRI loop that is designated as a T-loop. Unlike PRI lines,

these lines can be set to either manual or automatic answer when using for remote call-ins.

The following paths indicate where to access the line configuration menu through Element

Manager and through Telset Administration:

• Element Manager: Configuration > Telephony > Lines > Active Physical Lines, Inactive

Lines, All Lines

• Telset interface: **CONFIG > Lines

1 2 ... 220 221 222 223 224 225 226 227 228 229 230 ... 757 758

Komentáře k této Příručce

Žádné komentáře

Avaya BCM 4.0 Networking Průvodce konfigurací Strana 225

Komentáře k této Příručce

Související produkty a manuály pro Sítě Avaya BCM 4.0 Networking