Avaya BCM 4.0 Networking Průvodce konfigurací stáhnout pdf (Strana 59)

100

101

Chapter 2 System telephony networking overview 59

BCM 4.0 Networking Configuration Guide

• Originating Line Identification (OLI) for incoming and outgoing calls:

— For incoming calls, the Calling Line Identification (CLI/CLID) information is displayed to

the user on telephones with line display. This must be configured in programming.

— For outgoing calls, the directory number of the originating party is sent out as OLI.

• Terminal Line Identification (TLI) for incoming and outgoing calls. Referred to as Called Line

Identification.

• Selective Line Redirect (SLR) and External Call Forward (ECF) implemented on calls

between DPNSS 1, and BRI/PRI, DASS2, and analog lines.

• These remote access features are supported on DPNSS: DDI, line pool access code,

destination codes, and remote page feature codes.

DPNSS to Embark connections

DPNSS lines connected to an Embark switch perform call redirection/diversion using the Call

Forward feature to create a tandem link back to the switch. Since this is different from other

switches, you must select the type of switch DPNSS will be connecting to when you do module

programming.

Before you program Call Forwarding, ensure that:

• Both real channels and virtual channels are provisioned.

• Destination or line pool codes are programmed for the DPNSS to Embark link.

Also, during programming for Call Forward No Answer and Call Forward on Busy, when you

enter the Forward to: digits, the system performs a validation check with the switch on the

number. (Configuration > Telephony > Sets > Active Sets > Line Access > Properties tab)

DPNSS 1 features

The following features are available and can be programmed over DPNSS lines:

• “Three party service” on page 60

•Diversion (“Using the diversion feature” on page 61)

• Redirection (“Using the Redirection feature” on page 62)

• “Executive intrusion” on page 62

• “Call Offer” on page 63

• “Route optimization” on page 64

• “Loop avoidance” on page 65

• Message Waiting Indication

The following parameters can be configured for DPNNS 1 lines:

• Line type

•Prime set

Note: Keycodes are required to enable DPNSS 1.

1 2 ... 54 55 56 57 58 59 60 61 62 63 64 ... 757 758

Komentáře k této Příručce

Žádné komentáře

Avaya BCM 4.0 Networking Průvodce konfigurací Strana 59

Komentáře k této Příručce

Související produkty a manuály pro Sítě Avaya BCM 4.0 Networking