Avaya BCM 4.0 Networking Průvodce konfigurací Strana 520

  • Stažení
  • Přidat do mých příruček
  • Tisk
  • Strana
    / 758
  • Tabulka s obsahem
  • KNIHY
  • Hodnocené. / 5. Na základě hodnocení zákazníků
Zobrazit stránku 519
520 Chapter 60 Configuring the WAN resources
N0060606N0060606
Figure 161 Multilink PPP Parameters panel
Table 18 Multilink PPP Parameters panel details
Attribute Value Description
Multilink PPP Disable
Enable
Select to enable Multilink PPP on this interface
The setting you choose for Fragmentation Status must be the same
as the setting on the other end of the PPP link.
Default: Disable
Fragmentation trigger Frame size
Delay Time
Select Frame size if you want BCM to use the size of the packet to
decide if the packets need to be fragmented.
Select DelayTime if you want BCM to use delay time to decide if the
packets need to be fragmented.
Default: Frame size
Frame size <160-800> Parameter is only available if you selected Frame size for the
Fragmentation Trigger parameter.
Enter the maximum frame size in bytes. Any packets that have a
frame size larger than the size specified are fragmented.
Default: 256
Maximum received
reconstructed unit
<64-1614> Maximum number of octets that can be in the information field of the
reassembled packet.
Default: 1500
Short sequence
number
<check box> Select if you want to receive fragments with short, 12-bit sequence
numbers.
Default: Disabled
Endpoint
discriminator class
<0-5> Multilink Class for the Endpoint Discriminator.
Default: 1
Endpoint
discriminator value
Multilink identifier address for the Endpoint Discriminator.
Default: BCM
Zobrazit stránku 519
1 2 ... 515 516 517 518 519 520 521 522 523 524 525 ... 757 758

Komentáře k této Příručce

Žádné komentáře