Avaya BCM 4.0 Networking Průvodce konfigurací Strana 549

  • Stažení
  • Přidat do mých příruček
  • Tisk
  • Strana
    / 758
  • Tabulka s obsahem
  • KNIHY
  • Hodnocené. / 5. Na základě hodnocení zákazníků
Zobrazit stránku 548
Chapter 62 Configuring the Dial-up resources 549
BCM 4.0 Networking Configuration Guide
Figure 170 Access Parameters
ISDN Dial-out
BCM 4.0 supports ISDN dial-out for dial-on-demand WAN access. You can use ISDN BRI/PRI as
a persistent or dial-on-demand WAN connection or as a backup for your permanent WAN
connection.
To reserve WAN resources, see “ISDN WAN (Dial-up/Nailed-up)” on page 88.
Refer to the following topics for information:
“Creating an ISDN dial out interface”
“Configuring an ISDN interface” on page 550
“ISDN Channel Characteristics” on page 551
“To delete an ISDN interface” on page 555
Table 125 Access parameters
Attribute Value Description
Modem Access Parameters
Dial-out user name nnadmin
BTRemoteIsdn
Select a user name that the link uses to authenticate itself when dialing
out to another router.
Default: nnadmin
Authentication CHAP
PA P
Select authentication type for the link.
CHAP is used first and if the receiving end of the link declines.
PAP is used to authenticate the link.
Two - way
Authentication
Enabled
Disabled
Enable or disable link authentication in both directions.
Default: Disabled.
Note: To use an ISDN dial-out connection, you must first configure your system for
ISDN. For more information, refer to “ISDN overview” on page 709. If your system is
already configured to support ISDN, make sure you configure a Data Module for ISDN
dial-out connection. For more information, see “Configuring a data module” on page 532.
After you have created an ISDN dial-out interface, you must use “Configuring Net Link
Manager” on page 567 to select which type of network connection the system must use for
primary and backup connection.
Zobrazit stránku 548
1 2 ... 544 545 546 547 548 549 550 551 552 553 554 ... 757 758

Komentáře k této Příručce

Žádné komentáře