Avaya BCM 4.0 Networking Průvodce konfigurací stáhnout pdf (Strana 563)

100

101

Chapter 62 Configuring the Dial-up resources 563

BCM 4.0 Networking Configuration Guide

Figure 179 Deleting a PPPoE Interface

Auto dial-out

Management applications such as SNMP trap dial out, Scheduled Log transfer, Scheduled Backup,

and Scheduled CDR records transfer can use automatic dial-out over an ISDN or Modem

interface. To configure the automatic data transfer, the administrator must configure a static route,

with the auto dial-out field selected, and associate it with the application. When data is sent to the

destination address, the network recognizes the address of the application, and triggers the dial-out

to establish the connection.The packets are then sent over the link to the destination.

Notes:

• The dial-out interface must be enabled to configure static routes.

• The disconnect time for the interface must be greater than 60 seconds. This is configured on

the Link Parameters tab of the selected interface under Configuration > Resources >

Network Interfaces.

• Auto dial-out routes cannot be added if the interface is already manually connected, unless the

interface is already connected with auto dial-out routes configured.

1 2 ... 558 559 560 561 562 563 564 565 566 567 568 ... 757 758

Komentáře k této Příručce

Žádné komentáře

Avaya BCM 4.0 Networking Průvodce konfigurací Strana 563

Komentáře k této Příručce

Související produkty a manuály pro Sítě Avaya BCM 4.0 Networking