Avaya Business Communication Manager 5.0 - Configuration - Devices Uživatelský manuál stáhnout pdf (Strana 224)

224 Feature references

Nortel Business Communication Manager 5.0

Configuration — Devices

NN40170-500 02.04 Standard

August 2009

Feature Settings panel

There are a number of settings that define telephony operation for the entire

system. These have been gathered on one panel, separated into sections.

They affect different aspects of how various features act, or if they are allowed

on the system.

The following paths indicate where to access global telephony settings in

Element Manager and through Telset Administration:

Element Manager: Configuration > Telephony > Global Settings > Feature

Settings

Telset interface: **CONFIG > System Prgrming > Featr settings

Do not Disturb on Busy If this feature is active, the set does not receive notification of

incoming Hunt group calls.

Group Pickup If a set is part of a Hunt group and a call pickup group, then an

incoming Hunt group call can be picked up from any set that is in

the call pickup group.

Transfer via Hold The system supports transfer for Hunt group sets. However, you

cannot Transfer by using Hold. Once you answer a call on a Hunt

group set, the Hunt group notification disappears from all other

sets in the Hunt group.

Priority Call You cannot make Priority calls to Hunt group DNs.

Ring Again You cannot use Ring Again when calling a Hunt group DN.

Line Redirection

The Allow redirect attribute must be selected for DNs

assigned to Hunt groups.

Page Zones You cannot include Hunt group DNs in a Page zone.

Voice Call Hunt groups cannot accept voice calls. Answer buttons have no

appearances for voice calls, and the set does not ring.

Feature Description

Table 7 Hunt Group feature operation

Feature Description

1 2 ... 219 220 221 222 223 224 225 226 227 228 229 ... 257 258

Žádné komentáře

Avaya Business Communication Manager 5.0 - Configuration - Devices Uživatelský manuál Strana 224