Avaya Business Communication Manager 5.0 - Configuration - Devices Uživatelský manuál stáhnout pdf (Strana 57)

Basic parameters for digital sets configuration 57

Nortel Business Communication Manager 5.0

Configuration — Devices

NN40170-500 02.04 Standard

August 2009

Job aid: Notes about assigning lines to telephones

Nortel recommends a maximum of four line buttons per telephone. You can

program more than four line buttons on a telephone by programming less than

four on other sets. For example, you might program 20 line buttons on a

receptionist telephone equipped as a CAP station, and only two lines on all

other telephones.

For BCM450, you can program a maximum of 93 telephones with a line

appearance for a specific line, including VoIP and target lines. Above this

maximum, you can configure more than one appearance per telephone of a

target line.

Note: This facility is not available in BCM50.

Do not assign auto-answer loop start trunks, auto-answer T1 E&M trunks, and

T1 DID trunks to telephones. These trunks are used to monitor incoming call

usage, or to place outgoing calls (auto-answer loop start and T1 E&M trunks).

A line that is configured as private cannot be assigned to another telephone.

Each line assigned to a telephone must appear to a button with an indicator.

The maximum number of available buttons is 8 for the 7208 digital telephones,

10 for the model 7310, 10 for 7316 digital telephones, 16 for the 7316E digital

telephone, and 24 for the model 7324 digital telephones. You need at least two

intercom buttons to use the conference feature.

Priv. OLI Enter or confirm the number that displays at the far end for calls

going over the private network. This number is usually the same

as the DN (only on digital and VoIP trunks). OLI numbers can be

bulk changed using the Renumber button available under

Configuration>Telephony>Sets>All DNs.

Fwd No Answer Enter the number of the device that receives calls when this

telephone does not answer. The device can be another

telephone or a voice mail service

Fwd Delay Confirm or change the number of rings you want to occur at the

telephone before a call is forwarded. (Default: 4).

Fwd Busy Enter the number of the device you want to receive calls when

this telephone is busy. This can be another telephone or a voice

mail service.

Fwd All Enter the number of the device where all calls to this telephone

are forwarded.

Variable Value

1 2 ... 52 53 54 55 56 57 58 59 60 61 62 ... 257 258

Žádné komentáře

Avaya Business Communication Manager 5.0 - Configuration - Devices Uživatelský manuál Strana 57