Avaya Configuring SNMP, BOOTP, DHCP, and RARP Services Uživatelský manuál stáhnout pdf (Strana 25)

Starting SNMP, BootP, DHCP, and RARP Services

303542-A Rev 00

1-7

Starting BootP Services

You must use Site Manager to start BootP. The BCC is not supported.

Before you can run BootP services, you must enable IP on the router. You can,

however, enable IP and BootP on the router simultaneously. If you want to add

BootP to a circuit on which you have already configured IP, refer to Configuring

and Managing Routers with Site Manager for more information about adding a

protocol.

When you enable BootP, you are required to configure only a few parameters. The

Configuration Manager supplies values for the remaining parameters.

Enabling BootP on an Interface

When you select either a link- or net-module connector, or when you finish

configuring a WAN circuit, the Select Protocols window opens.

To enable BootP on an interface, complete the tasks in the following table

Note:

The Select Protocols window displays only those protocols that the

circuit type supports.

Site Manager Procedure

You do this System responds

1. In the Configuration Manager window,

select the link- or net-module connector on

which you are enabling BootP services.

The Select Protocols window opens.

2. Choose

BOOTP

When you choose BOOTP, you

automatically choose IP.

The BOOTP menu opens.

3. Click on

. The IP Configuration window opens.

(continued)

1 2 ... 20 21 22 23 24 25 26 27 28 29 30 ... 145 146

Žádné komentáře

Avaya Configuring SNMP, BOOTP, DHCP, and RARP Services Uživatelský manuál Strana 25