Avaya Configuring SNMP, BOOTP, DHCP, and RARP Services Uživatelský manuál stáhnout pdf (Strana 28)

Configuring SNMP, BootP, DHCP, and RARP Services

1-10

303542-A Rev 00

Starting RARP Services

Before you can enable RARP services, you must enable IP on the router. You can,

however, enable IP and RARP services on the router simultaneously. If you want

to add RARP to a circuit on which you have already configured IP, see

Configuring and Managing Routers with Site Manager for information about

adding a protocol.

When you enable RARP services, you are required to configure only a few

parameters. The Configuration Manager supplies default values for the remaining

parameters.

Enabling RARP on an Interface

When you select either a link- or net-module connector, or when you finish

configuring a WAN circuit, the Select Protocols window opens.

To enable RARP on an interface, complete the tasks in the following table

Note:

The Select Protocols window displays only those protocols that the

circuit type supports.

Site Manager Procedure

You do this System responds

1. In the Configuration Manager window,

select the link- or net-module connector on

which you are enabling RARP services.

The Select Protocols window opens.

2. Choose

Reverse ARP

When you choose Reverse ARP, you

automatically choose IP.

3. Click on

. The IP Configuration window opens.

(continued)

1 2 ... 23 24 25 26 27 28 29 30 31 32 33 ... 145 146

Žádné komentáře

Avaya Configuring SNMP, BOOTP, DHCP, and RARP Services Uživatelský manuál Strana 28