Avaya Configuring SNMP, BOOTP, DHCP, and RARP Services Uživatelský manuál Strana 53

  • Stažení
  • Přidat do mých příruček
  • Tisk
  • Strana
    / 146
  • Tabulka s obsahem
  • KNIHY
  • Hodnocené. / 5. Na základě hodnocení zákazníků
Zobrazit stránku 52
Customizing SNMP
303542-A Rev 00
3-3
Customizing SNMP Global Parameters
You can enable SNMP services most easily by accepting all the default parameter
values. However, you may want to change these values, depending on your
network requirements. This chapter describes choices you can make to use SNMP
most effectively on your network.
Disabling and Reenabling SNMP
When you enable IP on an interface, SNMP access is automatically enabled
through that interface, and default values are in effect for all SNMP parameters
(see Appendix B for parameter defaults).
Using the BCC
To disable SNMP, navigate to the SNMP prompt and enter:
disable
For example, the following command disables SNMP:
snmp#
disable
To reenable SNMP, navigate to the SNMP prompt and enter:
enable
For example, the following commands reenable SNMP and display its default
values:
snmp#
enable
snmp#
info
on box
state enabled
lock enabled
lock-address 0.0.0.0
Determining When to Record Threshold Events
Specifying Maximum Successive Alarms
Specifying Polling Intervals for Held Variables
Specifying a Threshold Object Name
Table 3-1. SNMP Configuration Tasks
(continued)
Zobrazit stránku 52
1 2 ... 48 49 50 51 52 53 54 55 56 57 58 ... 145 146

Komentáře k této Příručce

Žádné komentáře