Avaya Configuring SNMP, BOOTP, DHCP, and RARP Services Uživatelský manuál stáhnout pdf (Strana 27)

Starting SNMP, BootP, DHCP, and RARP Services

303542-A Rev 00

1-9

Enabling DHCP on an Interface

When you select either a link- or net-module connector, or when you finish

configuring a WAN circuit, the Select Protocols window opens.

To enable DHCP on an interface, complete the tasks in the following table

Customizing DHCP

For information about modifying DHCP parameters, see Chapter 5,

“Customizing DHCP.”

Note:

The Select Protocols window displays only those protocols that the

circuit type supports.

Site Manager Procedure

You do this For instructions, see

1. Enable BootP on the interface. “Enabling BootP on an Interface

” on page

1-7

2. Access the BootP Relay Agent Interface

Table window.

“Customizing BootP Relay Agent

Parameters” on page 4-2.

3. Set the

Pass Through Mode

parameter to

DHCP, or to BootP and DHCP. This action

allows you to select either DHCP, or BootP

and DHCP, for the

Pass Through Mode

parameter in other windows.

“Specifying the Relay Mode for Packet

Forwarding” on page 4-4.

4. Click on

Apply

5. Edit the other parameters in this window. “Customizing BootP Relay Agent

Parameters” on page 4-2.

1 2 ... 22 23 24 25 26 27 28 29 30 31 32 ... 145 146

Žádné komentáře

Avaya Configuring SNMP, BOOTP, DHCP, and RARP Services Uživatelský manuál Strana 27