Avaya Configuring SNMP, BOOTP, DHCP, and RARP Services Uživatelský manuál Strana 26

  • Stažení
  • Přidat do mých příruček
  • Tisk
  • Strana
    / 146
  • Tabulka s obsahem
  • KNIHY
  • Hodnocené. / 5. Na základě hodnocení zákazníků
Zobrazit stránku 25
Configuring SNMP, BootP, DHCP, and RARP Services
1-8
303542-A Rev 00
Customizing BootP
For information about customizing BootP parameters, see Chapter 4,
“Customizing BootP.
Starting DHCP Services
Before you can enable DHCP services, you must enable IP and BootP on the
router. You can, however, enable IP, BootP, and DHCP on the router
simultaneously. If you want to add BootP and DHCP to a circuit on which you
have already configured IP, see Configuring and Managing Routers with Site
Manager for information about adding a protocol.
When you enable BootP and DHCP, you are required to configure only a few
parameters. The Configuration Manager supplies default values for the remaining
parameters.
4. Specify an IP address for this interface.
There is no default for the IP address. You
must supply an address or enter 0.0.0.0 to
indicate that this is an unnumbered
interface. For information about
unnumbered interfaces, see
Configuring
IP Services
.
5. Edit or accept default values for the
remaining IP interface parameters:
To accept the default values, click on
OK.
To edit IP interface parameters, click
on
Details
. For information about
editing IP interface parameters, see
Configuring IP Services
.
Site Manager Procedure
(continued)
You do this System responds
Zobrazit stránku 25
1 2 ... 21 22 23 24 25 26 27 28 29 30 31 ... 145 146

Komentáře k této Příručce

Žádné komentáře