Avaya Configuring WAN Lines Services Uživatelský manuál stáhnout pdf (Strana 147)

100

101

Configuring MCE1 and MCT1 Services

308648-14.00 Rev 00

7-13

Setting the Line Impedance (MCE1 Net Modules Only)

The line impedance for the ASN MCE1 net module is 120 ohm by default. For the

ASN MCE1 net module only, you can change the line impedance to 75 ohm for

this MCE1 interface.

Using the BCC

To change line impedance, navigate to the mce1 prompt (for example,

stack

;

mce1/1/2/1

) and type:

line-impedance

variable

For example:

mce1/1/2/1#

line-impedance bnc-75-ohms

mce1/1/2/1#

line-impedance rj45-120-ohms

Using Site Manager

See the Line Impedance parameter on page A-27 for information.

Setting the FDL Loop Interframe Fill

In the BCC, the FDL Loop Interframe Fill parameter is set to mark by default.

This enables the detection of loop retention code when the remote end is in line or

payload loopback. When you set this parameter to loop-retention, the loop

retention interframe time fill for the facility data link (FDL) is enabled after

sending loop-up code.

Using the BCC

To set this parameter, navigate to the mce1 prompt (for example, |

stack

;

mce1/1/2/1

) and type:

fdl-loop-interframe-fill

variable

For example:

mce1/1/2/1#

fdl-loop-interframe-fill loop-retention

1 2 ... 142 143 144 145 146 147 148 149 150 151 152 ... 461 462

Komentáře k této Příručce

Žádné komentáře

Avaya Configuring WAN Lines Services Uživatelský manuál Strana 147

Komentáře k této Příručce

Související produkty a manuály pro Sítě Avaya Configuring WAN Lines Services