Avaya Configuring WAN Lines Services Uživatelský manuál Strana 214

  • Stažení
  • Přidat do mých příruček
  • Tisk
  • Strana
    / 462
  • Tabulka s obsahem
  • KNIHY
  • Hodnocené. / 5. Na základě hodnocení zákazníků
Zobrazit stránku 213
Configuring WAN Line Services
8-12
308648-14.00 Rev 00
Setting the Remote FDL HDLC Address Mode
You can select the FDL HDLC address mode to determine how the local FDL
responds to HDLC addresses in messages from the remote FDL.
Set the FDL address mode to by (the default) or az for this FT1 interface.
Using the BCC
To set the FDL HDLC address mode, navigate to the ft1 prompt (for example,
box
;
ft1/1/1
) and type:
fdl-target-hdlc-address
variable
For example:
ft1/1/1#
fdl-target-hdlc-address az
Using Site Manager
See the Remote FDL HDLC Address Mode parameter on page A-47 for
information.
Accepting or Rejecting Port Loopback Requests
By default, the FT1 port accepts requests from a remote device to go into
loopback mode. During loopback, the port loops receive data back onto the T1
transmit path. The remote or intermediate test equipment then performs
diagnostics on the network between the equipment and the port.
To prevent the port from accepting loopback requests, you can disable detection of
remote loop-up and loop-down code.
Using the BCC
To enable or disable port loopback requests, navigate to the ft1 prompt (for
example,
box
;
ft1/1/1
) and type:
accept-loopback-request
variable
For example:
ft1/1/1#
accept-loopback-request enabled
Zobrazit stránku 213
1 2 ... 209 210 211 212 213 214 215 216 217 218 219 ... 461 462

Komentáře k této Příručce

Žádné komentáře