Avaya Configuring WAN Lines Services Uživatelský manuál stáhnout pdf (Strana 71)

100

101

Configuring Synchronous Services

308648-14.00 Rev 00

2-23

KG84A Cycle

By default, the timer cycle is set to 100 milliseconds (ms). This cycle value is used

by the timers on the other KG84A devices on the network. This value also

becomes the polling cycle for monitoring FCS errors.

Set the KG84A timer cycle to 5, 10, 25, 50, 100, 200, or 500 ms on this interface.

Using Site Manager

See the KG84A Cycle parameter on page A-80 for information.

KG84A Sync Loss Interval

By default, the router waits 50 cycles after detecting an FCS error to receive a

valid frame before declaring a loss of synchronization.

Set the KG84A loss interval to 5, 10, 25, 50, 100, 200, or 500 cycles on this

interface.

Using Site Manager

See the KG84A Sync Loss Interval parameter on page A-81 for information.

KG84A Remote Resync Wait

By default, the router waits 200 cycles when synchronization is lost and a

remotely initiated resynchronization has been detected. You can set the number of

cycles that the router waits for the remote KG84A device to complete a

resynchronization operation to 2, 5, 10, 25, 50, 100, 200, or 500. After this

number of cycles, the router determines that the resynchronization failed and

initiates another resynchronization.

Note that if you press the RESYNC button on the local KG84A device, the router

responds as if it detected a remotely initiated resynchronization.

Use different settings at each end of the point-to-point link to avoid a possible race

condition.

Configure the KG84A remote resynchronization wait on this interface.

1 2 ... 66 67 68 69 70 71 72 73 74 75 76 ... 461 462

Komentáře k této Příručce

Žádné komentáře

Avaya Configuring WAN Lines Services Uživatelský manuál Strana 71

Komentáře k této Příručce

Související produkty a manuály pro Sítě Avaya Configuring WAN Lines Services