
Using Technician Interface Scripts
2-548
backup_dialing pools [
<pool ID>
[
<circuit name>
]]
Displays detailed line information for each line in each pool. You can display information
about all pools, a specific pool, and/or a specific circuit on the specified pool. The display
includes the following information:
Circuit Information:
Synchronous Line Information:
Primary Circuit Identifies the primary circuit.
Primary DownTime Number of seconds the router waits before bringing up the line.
This delay prevents the line from going up and down if this is a
reactivated primary line and there are problems on the line.
Outgoing Phone Number Telephone number of the remote router.
Extension Extension line for a main telephone number.
Phone # Type Indicates whether the phone type is Dial or ISDN.
Slot Num Identifies the slot where this line resides.
Port Num Identifies the port where this line connects.
Line State State of the line, which can be one of the following:
• Down – Line is not operational.
• DSR Wait – External equipment, such as a modem, DSU, or
CSU, is not currently up and thus is not sending a Data Set
Ready signal.
• HoldDown – Line is in holding mode.
• Init – Line is initializing.
• LMI Wait – Line is waiting for the WAN protocol to indicate that
a link layer connection has been established to another device.
• Not Pres – Line is enabled but not active. This state occurs for
several reasons. For example, the Link Module may not be
physically present in the chassis. The software may be booting
and has not yet initialized. The slot may be running diagnostics.
Or there may be a problem with the configuration.
• Up – Line is operating normally.
Active Circuit Name of the circuit using this line.
Komentáře k této Příručce