
show sws
2-553
bandwidth pool [
<pool ID>
[
<circuit name>
]]
Displays detailed line information for each line in each pool. You can display information
about all pools, a specific pool, and/or a specific circuit in the specified pool. The display
includes the following information:
Circuit Information:
Synchronous Line Information:
Primary Circuit Identifies the primary circuit.
Bandwidth Mode Operating mode of the router, as follows:
• Monitor–designates the router as the congestion monitor for the
primary line.
• Non-monitor–indicates that the router does not monitor congestion
on the primary line.
Inactivity Time (Sec) Number of seconds the router waits without receiving data across the
line before bringing down the connection.
Outgoing Phone Number Telephone number of the remote router.
Extension Extension line for a main telephone number.
Phone # Type Indicates whether the phone type is Dial or ISDN.
Slot Num Identifies the slot where this line resides.
Port Num Identifies the port where the line connects.
Line State State of the line, which can be one of the following:
• Down – Line is not operational.
• DSR Wait – External equipment, such as a modem, DSU, or CSU,
is not currently up and thus is not sending a Data Set Ready signal.
• HoldDown – Line is in holding mode.
• Init – Line is initializing.
• LMI Wait – Line is waiting for the WAN protocol to indicate that a
link layer connection has been established to another device.
• Not Pres – Line is enabled but not active. This state occurs for
several reasons. For example, the Link Module may not be
physically present in the chassis. The software may be booting and
has not yet initialized. The slot may be running diagnostics. Or
there may be a problem with the configuration.
• Up – Line is operating normally.
Komentáře k této Příručce