Avaya Configuring IP, ARP, RIP, and OSPF Services Uživatelský manuál stáhnout pdf (Strana 192)

Configuring IP, ARP, RIP, and OSPF Services

6-22

117356-E Rev 00

By default, OSPF assumes that the interface is attached to a broadcast network.

You can use the BCC or Site Manager to specify another network type.

Using the BCC

To change the interface type, navigate to an OSPF interface prompt (for example,

box; eth 2/2; ip/2.2.2.2/255.255.0.0; ospf

) and enter:

type <

interface_type>

interface_type

is one of the interface types described in Table 6-2.

Using Site Manager

To change the interface type, complete the following tasks:

Table 6-2. OSPF Interface Types

Type Description

broadcast Default. Choose broadcast if this network is a broadcast LAN, such as

Ethernet.

nbma Choose nbma (nonbroadcast multi-access) if the network is a

nonbroadcast network, such as X.25.

pointopoint Choose point-to-point for a synchronous, point-to-point interface.

ietf Choose ietf if the network is a point-to-multipoint network.

pmp Choose pmp (point-to-multipoint) if you want to use the Bay Networks

proprietary solution for frame relay point-to-multipoint networks.

passive Choose passive to configure an interface that OSPF cannot use to form

neighbor relationships. OSPF cannot accept Hello messages or send

advertisements on the passive interface.

Site Manager Procedure

You do this System responds

1. In the Configuration Manager window,

choose

Protocols

The Protocols menu opens.

2. Choose

. The IP menu opens.

3. Choose

OSPF/MOSPF

. The OSPF/MOSPF menu opens.

(continued)

1 2 ... 187 188 189 190 191 192 193 194 195 196 197 ... 361 362

Žádné komentáře

Avaya Configuring IP, ARP, RIP, and OSPF Services Uživatelský manuál Strana 192