
Configuring IP, ARP, RIP, and OSPF Services
A-24
117356-E Rev 00
Parameter: Enable Default Route for Subnets
Path: Configuration Manager > Protocols > IP > Global
Default: Disable
Options: Enable
|
Disable
Function: Specifies whether the IP router uses a default route for unknown subnets. The
default route must be present in the routing table. When you set this parameter
to Enable, the IP router uses a default route. When you set this parameter to
Disable, the IP router does not use a default route.
Instructions: Accept the default, Disable, if you do not want the IP router to use a default
route for unknown subnets. Otherwise, reset this parameter to Enable.
MIB Object ID: 1.3.6.1.4.1.18.3.5.3.2.1.1.14
Parameter: Maximum Policy Rules
Path: Configuration Manager > Protocols > IP > Global
Default: 32
Options: Any integer
Function: Specifies the maximum number of policies that can be configured per policy
type (accept or announce) per protocol.
Instructions: To configure more than 32 accept or announce policy rules for a protocol, you
must set this parameter to a larger value. IP will round the value up to the next
multiple of 32.
MIB Object ID: 1.3.6.1.4.1.18.3.5.3.2.1.1.15
Parameter: Route Filter Support
Path: Configuration Manager > Protocols > IP > Global
Default: Enable
Options: Enable
|
Disable
Function: Specifies whether or not IP supports route filters.
Instructions: If you do not require support for route filters, select Disable. Otherwise, accept
the default.
MIB Object ID: 1.3.6.1.4.1.18.3.5.3.2.1.1.16
Komentáře k této Příručce