Avaya Configuring IP, ARP, RIP, and OSPF Services Uživatelský manuál stáhnout pdf (Strana 98)

Configuring IP, ARP, RIP, and OSPF Services

3-36

117356-E Rev 00

To configure source route end-station support on a per-circuit basis and choose

STE or ARE ARP packets, complete the following tasks:

Configuring an SMDS Address

By default, if the interface is connected to an SMDS network, IP uses the

SMDS-configured addresses.

You can use Site Manager to supply the following:

• A complete SMDS E.164 address specified by the SMDS subscription

agreement that you have with your SMDS provider

• An address-resolution multicast address for this IP interface in an SMDS

network

Site Manager Procedure

You do this System responds

1. In the Configuration Manager window,

choose

Protocols

The Protocols menu opens.

2. Choose

. The IP menu opens.

3. Choose

Interfaces

. The IP Interface List window opens.

4. Click on the interface that you want to edit. Site Manager displays the parameter

values for that interface in the IP Interface

List window.

5. Set the following parameters:

•

TR End Station

•

TR Endstation ARP Type

Click on

Help

or see the parameter

descriptions beginning on page A-11

6. Click on

Apply

, and then click on

Done

. You return to the Configuration Manager

window.

Note:

Make sure to enter the correct addresses for the MAC Address, SMDS

Group Address, and SMDS Arp Request Address parameters. These addresses

are the same as those you entered for the Individual Address, Group Address,

and ARP Address parameters in the SMDS Configuration window when you

configured SMDS.

1 2 ... 93 94 95 96 97 98 99 100 101 102 103 ... 361 362

Komentáře k této Příručce

Žádné komentáře

Avaya Configuring IP, ARP, RIP, and OSPF Services Uživatelský manuál Strana 98

Komentáře k této Příručce

Související produkty a manuály pro Sítě Avaya Configuring IP, ARP, RIP, and OSPF Services