Avaya Configuring IP, ARP, RIP, and OSPF Services Uživatelský manuál stáhnout pdf (Strana 245)

Site Manager Parameters

117356-E Rev 00

A-5

Parameter: Broadcast Address

Path: Configuration Manager > Protocols > IP > Interfaces

Default: Broadcast address specified when you added IP to the circuit

Options: 0.0.0.0 or any IP address

Function: Specifies the broadcast address that the IP router uses to broadcast packets.

Accepting 0.0.0.0 for the broadcast address specifies that the IP router will use a

broadcast address with a host portion of all ones. Accepting 0.0.0.0 does not

configure the router to use the address 0.0.0.0 to broadcast packets. For

example, if you set the IP address to 123.1.1.1 and the subnet mask to

255.255.255.0, accepting the default value 0.0.0.0 configures the IP router to

use the address 123.1.1.255 to broadcast packets. For the explicit broadcast

address of all ones, enter 255.255.255.255 for this parameter.

Instructions: Accept the default, 0.0.0.0, unless the calculated broadcast address (host

portion) of all ones is not adequate. If this is the case, then enter the appropriate

IP broadcast address in dotted-decimal notation.

MIB Object ID: 1.3.6.1.4.1.18.3.5.3.2.1.4.1.9

Parameter: Cost

Path: Configuration Manager > Protocols > IP > Interfaces

Default: 1

Options: 1 to the value of the RIP diameter (maximum 127)

Function: Sets the cost of this interface. The interface cost is added to routes learned on

this interface through RIP and is specified in subsequent RIP packets

transmitted out other interfaces.

Instructions: Enter the interface cost value (standard RIP implementation assigns a cost of 1);

however, keep in mind that increasing this value causes the upper bound set by

the RIP Network Diameter parameter to be attained more rapidly.

MIB Object ID: 1.3.6.1.4.1.18.3.5.3.2.1.4.1.8

1 2 ... 240 241 242 243 244 245 246 247 248 249 250 ... 361 362

Žádné komentáře

Avaya Configuring IP, ARP, RIP, and OSPF Services Uživatelský manuál Strana 245